Need help badly thanks

[Spider/Paleface513]

The new bulb don't stay in the mounting place because there's all that wire so the stock dust cover won't hold it in place like they di the stockers. Hers a video the instructions confuse me more I think i'm gonna need the splice wires as I didn't see any plugs that looked like any on my bike. Do I hook ballist to battery or just the hot wire from lighting harness. I hear a guy named Aaron can help me hers a video of the kit and all.
http://www.youtube.com/watch?v=VmOEGa5GOUo

[Spartan]

The # I sent you was for Colorado700R on here...I think you just need to get with him on how to modify your stock springs to fit it (maybe get a write up on here, Aaron?). Did you get a relay kit with this too? Without that they just hook up to the stock connectors. The 3 point triangle connector is what you have to splice in.

[Spider/Paleface513]

Everything I got was shown in video can only run them on high or low they dint two ways. Can I hook it up so on low and 2 on high.

[Spartan]

I only run them on lows on mine too, it's a single filament bulb so it can't be switched like stock. In your vid, the wires with the 2 prongs is what needs to be spliced, yes. cut the prongs off and cut off the wire from the stock bulbs (about halfway if you haven't) and splice the two ends together. Other than that you shouldn't need to put it to the battery.

[Spider/Paleface513]

Thanks Pat.

[Spartan]

If you're coming down here soon just bring the HIDs and your quad and I can help you out, really shouldn't take longer than a half hour to do it. It's just harder to explain it, really easy once you do it though.

[Spider/Paleface513]

Everything I got was shown in video can only run them on high or low they dint two ways. Can I hook it up so on low and 2 on high.

How do I splice the 3 point plug into two? I assume ones high ones low and other ground correct? Which wires which?

[Spartan]

Connect black wire on HID harness to black wire on 3pt plug, and for low beams I believe it's a green wire? I'll check it out on mine tomorrow when it's light out. You just leave one wire out from the 3pt.

[Krandall]

Is your kit the Hi/Low Kit?

[Spartan]

No his is the single mode standard kit.

[Spider/Paleface513]

Hooked it all up and couldn't get no light work on it more when I get back

[Spider/Paleface513]

 :confused:Think I need a new HID KIT or I F'd up. On the end that don't go to lights which ones the hot and which one negitive. I have no lights at all now. I attached red to green off triple plug and black to the blue nothings marked + or - on the light I assumed red posItive and blue negative. Am I wrong where do I get the kit with low/high beam that's truely plug and play no wire cutting? Or can I return these there's a one year warranty but had to cut wires so I could install so IDK if they're covered. 

[Spider/Paleface513]

In YouTube video which wire is positive and negative. Is it the ones with the big plugs on em? Is it the blue or the red positive? can anyone think off why I had no light is it ballist light or installed wrong? 

[Spartan]

I'll check my setup and let you know tomorrow, I'm sure it's something simple we can figure out.

[Spider/Paleface513]

I hope or I gotta buy wire set from triple plug down and replace stock lights,lol.