What did you do to your Raptor today?

[Ranger]

Just put on HIDs!

And preddy, no offense but I love your raptor's look

[Gunz]

word on the street is my pivot bearings showed up.. time to replace my 10 hour old bearings. :'(

Your secret is good with the Silver Lake crew......CRIPES!!!

[Gunz]

tried to find a dyno shop for it 

I bet I have a map for you.... send me a pm of what you have.

[Gunz]

Shawn, are you strut'n the front? What am I looking at in the pic (front)? Are you going to strut the rear?

[preddy08]

yea, the front is struted and the rear will be here shortly. Its sitting about 3-4 inches off the ground right now.

[Ranger]

Keep on struttin your stuff!

[Gunz]

After u get the rear done, give us a good pic of ur bike.

[dgreenbluet]

tried to put my new razrs on the rear and failed.  took the valvestem cores out and layed the rim on the side and put a 2X6 on it and drove my truck up the 2X6 and just snapped the 2X6 over and over again and the bead never gave! :'(  damn stock tires, guess ill just take it somewhere and let them do it for 10 bucks

[Colorado700R]

walmart

[Bert]

yea, the front is struted and the rear will be here shortly. Its sitting about 3-4 inches off the ground right now.

preddy
would you mind posting pics of your struts?

[Alkire193]

Chassis went to the welder, bottom end went back together.

[Ranger]

Fixed my dynatek install...TPS was set wrong in PC software (didn't open the throttle and save it)

[Krandall]

Chassis went to the welder, bottom end went back together.

gussset Kit?

[Alkire193]

Lots of damage from riding over the years.

[Krandall]

Lots of damage from riding over the years.

did you have a cracked frame?!