Yet another tear down pic thread

Started by preddy08, January 01, 2010, 01:54:40 PM

Previous topic - Next topic

preddy08

Started another tear down for the winter and thought I'd share some pics. I have'nt cleaned anything up for the pics, so this is how it looked after a season of riding. I was quite suprised at how clean everything looked. This was my second season on this motor.












Just a little 81hp trail bike.


preddy08

I was wondering about some of the tolerances. My cylinder was sleeved by Bo and has alot of hours on it. I'm debaiting weather or not to take it out to a 105.5 or not. I would like to stay a 105 with this same piston, but it was starting to burn alot of oil (single ring piston).



So here's what I got.



Top of cylinder - front to back 105.02mm

Top of cylinder - side to side 104.83mm



Piston measured from top, side to side 104.32mm

Piston measured from top, Front to back 104.25mm

Piston measured in middle of skirt, 104.85mm





To me this doesn't sound to bad, so what do ya think?
Just a little 81hp trail bike.


Peelz

looks super clean. wow. My stuff never looks that nice if I tear it apart.  :lol:
Krandall: "peelz. I'll be real with you. As much as I hate on you for soccer, I really don't mind it"


VelociRaptor

I would take it to 105.5, if ya want to stay 105 I would take this one on out and it be fresh with a piston and sell the combo(cylinder and piston) then sleeve another cylinder and reuse that piston(since its such great shape). I can rehone it for ya but it wont take the egg shape out of it enough and keep the piston to wall in check were it needs to be.

Krandall

Possible to take the sleeve out and put a new one in, or just not cost effective?


Sponsored by:
Yamaha Raptor Forum

PCIII Maps Here:
http://www.krandall.com

Cowards die many times before their deaths The valiant never taste of death but once

DL700

#5
CUSTOM 14:1 105.5 pistons are in the works and be here shortly

the galling on the wrist pin is all too common, ive honed a few rods to open up the clearances  a hair
CUERVO RACING

preddy08

Quote from: DL700 on January 03, 2010, 06:53:12 PM
CUSTOM 14:1 105.5 pistons are in the works and be here shortly

I've talked with RE and they have some in the works too. Should be here in the next two weeks or so.
Just a little 81hp trail bike.


DL700

 :thumbs: that what i was refering too ... didnt want to spill the beans till they were here... one quick call got those going :thumbs:
CUERVO RACING

Tim Barker

Quote from: preddy08 on January 03, 2010, 06:54:15 PM
Quote from: DL700 on January 03, 2010, 06:53:12 PM
CUSTOM 14:1 105.5 pistons are in the works and be here shortly

I've talked with RE and they have some in the works too. Should be here in the next two weeks or so.


I have both 105 and 105.5 14:1s on the shelf.

Barkers Performance
www.barkersexhaust.com

preddy08

Shitty Tim. I totally forgot to ask you about that when I spoke with ya :( well back to the drawing board.
Just a little 81hp trail bike.


Tim Barker

if you are going to run stock rod and don't want it to gall the wristpin you need to have the pin coated.
The galling is typical steel on steel

Barkers Performance
www.barkersexhaust.com