These EVAC valves have gotta go!

[Kenny]

I FINALLY have these dudes in my hand. I have 70 left out of the 100. Anyone who ordered last week that the machine shop was supposed to mail these to.... well, they will going priority mail this afternoon and in the morning. For those that don't know, these are the new design that I am selling for $65 til after X-Mas. They are on the home page of my website with the correct price.

KDS Racing - ATV throttle bodies, ported heads, etc....

[Blair]

kenny... remind me again what type of a benifit i will see with this???

[Kamakazi]

kenny... remind me again what type of a benifit i will see with this???

blair if you get one i guess ill have to get one as well, just give me a call and let me know, i may be ordering some other stuff from kenny as well 

[Kenny]

kenny... remind me again what type of a benifit i will see with this???

They not only help ring seal, they keep dirt and moisture from entering the vent tube and they eliminate the crankcase pressure that a single cylinder is always fighting. These things are usually good for a couple of hp, but we have seen as much as 4hp in the midrange on a good fresh build Rooster Built's dyno:hyper: Even when they don't show on a regular dyno chart, they improve loaded dyno run times and track times on everything we have put them on. These things really work well.  The strangest effect we have seen is that it helps the "dead" spot in the throttle response on big cams. It really shows up on the HC3. We have over 100 of the original design out there, and they always improve performance regardless of build. We have seen as much as 12-15 in/hg of vacuum in the crankcase (Raptor Randy tested)

[Krandall]

Kid Tested, Raptor Randy Approved.

[Kenny]

Kid Tested, Raptor Randy Approved.

Guaranteed not to rust, bust or collect dust

[Peelz]

so the valves keep your bike from sucking, they just make it blow?

they should be called....

wait for it















wait for it











wait for it........



















the preddy valve

[preddy08]

Heyyy ohhhh!!!!

Name it after me thats just fine, as long as I get one 

[Peelz]

Heyyy ohhhh!!!!

Name it after me thats just fine, as long as I get one 

[nikita]

wanna buy it send me a pm where to send my money.
THX

[Blair]

Eric if your getting one from kenny might as well make it 2...

[Krandall]

And might as well get me one too Kama...

[Blair]

back off krandall... haha... its a canadaian thing

[PnoT]

I wish you would put as much time into getting my brothers bike done and shipped as you do selling these Evac valves.   

[Kenny]

You better clear this up.