KDS +3 TB ?

Started by MORAPTOR700, December 05, 2009, 12:54:48 PM

Previous topic - Next topic

MORAPTOR700

I just purchased a used +3 TB and taking a few things off to clean up a check things. So I remove the Fast idle plunger unit and notice that rubber gasket is missing the center rubber to seperate the 2 sides of the plunger body. I'm sure I'm not explaining this right so I have inclosed a picture. I quess my question can that center rubber gasket be missing or should get a new gasket.

http://partsfinder.onlinemicrofiche.com/hondaeasttoledo/Yamaha_OEM/YamahaATV.asp?Type=13&A=387&B=11
Its the black rubber seal above the Fast idle plunger unit body it doesn't have a number. Also directly above the 3 screw. Like I said mine is missing the center section of the rubber. Thanks
2007 Raptor 700SE    Black/Orange

DL700

that is normal, the rubber gasket does not fully connect in that area
CUERVO RACING

MORAPTOR700

Quote from: DL700 on December 05, 2009, 01:14:15 PM
that is normal, the rubber gasket does not fully connect in that area

Yep your right. I pulled the stock TB apart and checked it and it was the same way. Thanks

Got another question what do you all use to get the TPS bolts out? Its a torx type bolt with that safety nipple in the center of it. I have a same T27 torx will that size work or is it metric. Thanks for the help again.
2007 Raptor 700SE    Black/Orange

DL700

cant recal the size but its std torx
CUERVO RACING

Colorado700R

isn't it a saftey torx? center pin style?

09RappySE

It is a saftey torx, T25 is the size.
734 09 Raptor
Meglodon by Bo,KW springs, Web 4 Cam, 54mm TB, 105.5mm CP cylinder, 12:1 CP,Barkers Inframe,Dynatek Coil,PC V,Dynatek Programable ignition,CCP stabilizer,+5 swinger,Boss Noss, Direct Drive Lock-up, KDS Evac valve,HID conversion,SPAL fan
Tuned by EHS Racing 74hp 52Tq

07 LT-R450
500cc Kit
Porting by Bo
DMC Pro Comp 4
Trinity intake
ATP intake Cam
Tuned by EHS 50hp 34Tq