Vapor Install Help

Started by MrStevie, June 01, 2008, 11:20:51 PM

Previous topic - Next topic

MrStevie

i'm hooking up my vapor kit and i'm not sure which wire to tap into for the RPM sensor, there are 2 wires coming out of the coil, can anyone tell me which one to splice into? the top looks like a red wire and the bottom is orange


also, where did you guys mount the vapor? i'm using the stock bracket that came with the kit and the stock handlebars
'08 Raptor 700r

Yamahauler

Figure it out Stevie? I did a search on some of the other forums, but I couldn't find anything out. I would just call Trailtech and ask them, they would deffinatly know.
2007 Yamaha Raptor 700
Blingstar Victoty Bumper
PRM-Products Grab Bar
ASV C5 Levers
Dr. D Reverse Lever
Tusk Power Pull Tether Kill Switch
GYTR Intake
FMF Powercore IV Exhaust
AC Nerfs
Shockwear Shock Covers
Iridium Plug
Razr-2s
Renthal 15 Tooth Front Sprocket
Protaper Bars

22Chet

follow the spark plug wire back and there was only 1 wire on mine.  ???
2006 Raptor 700
GYTR Exhaust
GYTR Intake
PCIII
15t Sprocket
TrailTech Vapor

MrStevie

Quote from: Yamahauler on June 03, 2008, 01:46:45 AM
Figure it out Stevie? I did a search on some of the other forums, but I couldn't find anything out. I would just call Trailtech and ask them, they would deffinatly know.
yeah i figured it out, i'm supposed to splice into the orange wire. i wired everything up but the rpm only reads from 750 to 900 at idle. that seems a little low, not sure if the vapor is reading right and i should adjust the idle screw, or if the vapor's wrong and i need to figure out what i did wrong
'08 Raptor 700r