Map help pc3

[speeddrive1]

I am wondering if anyone has a map for a stock bore with a full gytr pipe and intake with a hc3 cam?
I'm new here and think I will be spending some time here.  
Thanks.

[Warren]

hey welcome to the site.

you should check out this website to see if there is a map for your setup. if there isn't one on there you should be able to get one from somebody pretty easy.

here you go:

http://pciii.raptorsource.com

[Krandall]

Hey man,

The only map I have that is semi close is a GYTR Pipe w/ a HC2

I'll do some looking to see if I can find something to help you out.


Welcome aboard man!

[speeddrive1]

Ok , I seen that one. Do you think that would get me in the ballpark?

[Krandall]

Yeah, I know it'd get you in the area you need to be in. It'd just need more fuel in the top end range.

[speeddrive1]

Thanks Krandall, I will give it a try.
One more ? for ya. It has been a long time since I put the pipe, filter and pc3 on it and I don't ride it much. To load the map in the pc3 for the addition of the cam do I need to have the 9v battery hooked to it or just the usb cable from my laptop, ignition key on or off?

[Krandall]

If it's on the rappy. Just need the USB cable and turn the key on.

[speeddrive1]

Thanks again, you have been very helpful. :grin_nod:

[speeddrive1]

I hooked the usb cable to the power commander and turned the key on, the fuel pump ran and the pc powered up for about 4 seconds and then the light goes out andon my laptop says that it is not comunicating. Any ideas on what could be causing that?
I have the 9v adapter and am going to try that.
The thing I don't understand is that as soon as you hit the start button the pc powers back up and the bike starts.

[DL700]

start the  bike or use the 9v then load map

[speeddrive1]

Thanks DL700, I hate to sound like an idiot but I just want to make sure it's done right.
Installing the cam was a piece of cake for me, it's the loading the maps thats giving me a hard time.

[Krandall]

start the  bike or use the 9v then load map

dang... my bad!!!! I thought you could have the bike just turned on. Not running. 

9v for the win.

[speeddrive1]

no prob Krandall, I'm gonna try it when I get back to the shop and let you guys know if it works.

[Krandall]

How'd it go for you man?

[speeddrive1]

Yep, hooked the 9v to it and loaded it right up. Now I just have to wait till it quits raining so I can take it up the street to see how it runs.
We are heading out to St. Anthony in june, man I can't wait.