Sparks Big Core heat shield

Started by tonto13, February 19, 2009, 06:19:12 PM

Previous topic - Next topic

mustangracer42

Sounds good man.  I was waiting to hear back from you on Krandalls post

tonto13

Well finally have them done. Was going to try and extend the front over the y-section, but time did not let it happen. The longer one is the wifes and the shorter one is mine. The shields sit 1/2" off of the pipe.


MSAWS= My Sh*t Always Works Sometimes!
"99% of life is what you make of it, so if your life sucks, YOU SUCK!!!"
-Mike Muir (aka Tonto)


Krandall

dang dude that's SWEEET!!!!

Did you bend a full pipe to match the bend on your exhaust and cut it in half? It turned out great!


Sponsored by:
Yamaha Raptor Forum

PCIII Maps Here:
http://www.krandall.com

Cowards die many times before their deaths The valiant never taste of death but once

tonto13

Bent it to match and hand hammered it. Could have been better but also had a few other things to get done before Snakehunt here. So I did not get as much time as I would have liked to work on them.
MSAWS= My Sh*t Always Works Sometimes!
"99% of life is what you make of it, so if your life sucks, YOU SUCK!!!"
-Mike Muir (aka Tonto)


fastraptor

2006 Raptor 700r
Monster Duals
Skat Trak Haulers 8 paddle smooth buff fronts
Monster flow intake  Monster Box Fuel Controller
UMI Handlebars  Twist Throttle

mustangracer42

Million dollar question is......How much you want for one?  Looks nice