I need a new map for a big5 and sup6...

[Gunz]

I need a couple of maps

1st
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body
HotCam 2

2nd
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body

3rd
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
HotCam 2

Thanks to whoever can get me these maps. Dyno runs me $250 a wack.

[Krandall]

did you check out pciii.raptorsource.com?

[Gunz]

Yeah, that was the very 1st thing I did. No luck though.

[Krandall]

oops, my bad, didn't see you had a dynatek.

[Colorado700R]

I need a couple of maps

1st
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body
HotCam 2

2nd
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body

3rd
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
HotCam 2

Thanks to whoever can get me these maps. Dyno runs me $250 a wack.

Call Kam at KBR.  Might be able to hook you up 

[wobble]

I need a couple of maps

1st
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body
HotCam 2

Thanks to whoever can get me these maps. Dyno runs me $250 a wack.

My build is very close to that. I'm running setting #2 on the programmable ignition, but from what I've read #2 on the non-programmable is the same. You are welcome to try my map out if you'd like. It would get you very close.

[Bert]

Thanks to whoever can get me these maps. Dyno runs me $250 a wack.

There's a great dyno guy in Perry Iowa if your close...

[Gunz]

I need a couple of maps

1st
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body
HotCam 2

Thanks to whoever can get me these maps. Dyno runs me $250 a wack.

My build is very close to that. I'm running setting #2 on the programmable ignition, but from what I've read #2 on the non-programmable is the same. You are welcome to try my map out if you'd like. It would get you very close.

Yeah send it to me. detail your mods too, thanks
redmyk@cox.net

[Gunz]

I need a couple of maps

1st
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body
HotCam 2

2nd
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
+3 KDS throttle body

3rd
Barker inframes no qc
ProDesign w/KN no lid
PCIII
Dynatek non programmable
HotCam 2

Thanks to whoever can get me these maps. Dyno runs me $250 a wack.

Call Kam at KBR.  Might be able to hook you up 

Sent him a PM, thanks