Pistons are done*UPDATE*

[Kenny]

 I think the wife was just eyeballin' me on the way to her bath..... See you dudes later

[Colorado700R]

I think the wife was just eyeballin' me on the way to her bath..... See you dudes later

l8ter Kenny 

[Troy]

Beat it up like it owes you money

[Colorado700R]

Beat it up like it owes you money

or like it questions your evac valve !!   

[Bert]

What size is the stock bore cylinder?

[LAFURNACE]

102 is stock bore

[NaturalRaptor]

what would be your suggested Cam to match the 11-1 piston Kenny?

Just hang tight... I have something NASTY in the works

I like the sound of this! You have some great ideas. 

[Duane]

Nice, what deck height did you design them at?

[NaturalRaptor]

Kenny, are you still working on a new type of head gasket? 

[Troy]

.015'' in the hole

[air]

So are these are a true 11:1?

[Kenny]

Kenny, are you still working on a new type of head gasket? 

Yes! I called to try and have the guy fired today......He needs to hurry up since I approved the design 3 weeks ago!

So are these are a true 11:1?

Absolutely. 

[air]

So what are some of the other piston actually measuring at

[Kenny]

So what are some of the other piston actually measuring at

Usually a half point lower, just by the difference in how I measure mine. I actually calculate the area from the top ring to the piston crown. Mine will almost always measure 1/2 to 1 full point higher, but is less octane sensitive because of the improved quench

[RaptorRandy]

So what are some of the other piston actually measuring at

Usually a half point lower, just by the difference in how I measure mine. I actually calculate the area from the top ring to the piston crown. Mine will almost always measure 1/2 to 1 full point higher, but is less octane sensitive because of the improved quench

Yeah buddy......I'm ready for a 14:1 and some total seal rings, I need to get this thing back to it's full potential.....