I need a stock 700 cylinder

Started by Troy, July 30, 2008, 03:10:17 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Troy

July 30, 2008, 03:10:17 PM
I'm looking for a stock bore 700 cylinder in very good condition.

preddy08

#1
July 30, 2008, 03:50:43 PM
Quote from: troywcc on July 30, 2008, 03:10:17 PM
I'm looking for a stock bore 700 cylinder in very good condition.

LOL, good luck. Keep on eye out on the factory Nikasil. My bike was a low hour 07 and it was starting to wear through already. That is why I went big bore. It cost the same to have re-nikasiled as it were to cost to have the BBK sleeve installed.
Just a little 81hp trail bike.

Troy

#2
July 30, 2008, 04:22:37 PM
Yeah mine has a very tiny scratch in the nikasil, it would probably be ok but I'm not going to take any chances.  I'm actually considering going big bore at this point.  I can see a couple of light spots in the cylinder too.

preddy08

#3
July 30, 2008, 05:55:23 PM
Quote from: troywcc on July 30, 2008, 04:22:37 PM
Yeah mine has a very tiny scratch in the nikasil, it would probably be ok but I'm not going to take any chances.  I'm actually considering going big bore at this point.  I can see a couple of light spots in the cylinder too.


You might as well do the BBK. Here is Bos dyno compairing a 686 and 727.
http://www.raptorforum.com/forums/showthread.php?t=41878
Just a little 81hp trail bike.

Print
Go Up Pages1
User actions