PLASTICS/FENDERS:
These are from my '05 660. Mostly sand ridden, but it did get a couple seasons of some dirt/trail riding as well, so they're not perfect. There's some scratches and scuffs, and some discoloration on the left front fender. The white fenders just tend not to show a lot of this stuff well. (Bonus
)
I drag cut these, but never did take the time to go back and clean up the edges real nice with a file and/or sandpaper. So they are a little rough, but nothing that bothered me too much. Still decently clean.
The graphics kit was put on last year and is holding up well. There is one part on the left ( I think?) side by the seat that has started to peel slightly, but hasn't been an issue. I don't currently run the seat cover, but I will include that as well with the purchase. It matches the GYT-R tribal graphics and has a black gripper seat.
The billet grill that's in there now has a couple breaks where the flames get real thin in two spots I believe. I figured I'd just run it anyway, it looks good IMO and has held up well for me so far. No breaks since I got it (2nd owner).
I didn't shave off the tabs for the front fender mounts. I ran without the fender mounts, but you could go either way. I only ran without them because I relocated my key to under the fender.
The rear plastics have the battery box/electrical mounts cut off/out. To run these REARS you will NEED a custom battery box of some kind, along with somewhere to mount your recitfier/CDI, etc. If I can sell the whole plastic set together, I will include the box I used.
All tabs are good. Sale would include:
-White Front Drag cut plastics (w/ metal plug in reverse lever hole) w/ GYT-R Graphics
-White Rear Drag/Custom cut plastics w/ GYT-R Graphics
-Stainless Steel Battery box w/ ECU and recifier mounts
-White gas tank/cap cover
-Red Front Hood (minor scratch on the top 'bubble')
-Billet Flame Grill/Radiator guard.
-Stock black grill/radiator guard
-GYT-R/Gripper Seat Cover (matches plastics)
- White dash (good shape, missing one rubber mount piece on underside)
- Spare seat base. (this, along with the custom battery box allows you to ride without rear plastics at all.)
I think that's about it. Again, I'd like to sell these as a set first if possible. If they sit for a while unsold, I'll go ahead and seperate.
$125 freight. (should be reasonable freight as there's no HUGE fenders to try and find a box for
)
Pics:
Note- this is all I have right now that shows the battery box. As it sits in that picture it's setup for one of those bigger sideways batteries. I have a box on there at the moment for a stock size battery. I will include the other box for the larger battery if you like as well.
unmounted pics: Seat and tail light not included.
Couple pics of the battery box. I was planning on Powdercoating it black, but never got around to it. Tail light not included, and I'll either grind off the jimmyrigged taillight mount, or I can keep it on there if you like, either way.
FYI, those orange marks aren't rust, they're from the heat of the welder. :thumbsup: