Little Sahara dyno pulls and tunes w/specs. DYNO CHARTS inside.

[VelociRaptor]

I thought Tontos bike put down 56ftlbs on motor?

[EHSRACING]

is hefe bike actually stock and is the graph from the same dyno?

[Colorado700R]

it's not stock...is got allot of barker goodies inside and out

[Troy]

All the bikes were on the same dyno same day, one after the other.  Tonto's bike did make 58 pounds of torque on motor also.

[Gunz]

All the bikes were on the same dyno same day, one after the other.  Tonto's bike did make 58 pounds of torque on motor also.

Yeah to confusing to keep track. Roy just sent me a message to change his to 56tq.

[tonto13]

The first numbers on the dyno for mine were 72hp. and 58tq. But the downlow and mid were terrible. I got lucky with the tune. I do not remember the exact amount I gained downlow and in the mid range, but my quad runs so much better now. I truly cannot say thanks enough to Dyno Mike for the tune.

[frog69]

Heres my HOSS 53hp and 48tq not bad for stock plus 3

[Gunz]

a68h52tpt
a71h60tpm

[Tim Barker]

So right now we have a


83hp    58tq RE3 bike troy
81.5hp 58tq Bark2 bike gunz
72.5hp 60tq KDS2 bike Alkire
70hp    58tq Bo bike w/NOS 108hp 73tq Tonto

I can promise all but the KDS bike will continue to get tweaked on. I personally am hoping to get close to 90hp without changing bore, stroke, and compression. Once I get all I can out of it I really would like to throw a Barker3 or RE3 on her.

Put the 58tb on it and you should be much closer to what you are looking for.

[Gunz]

So right now we have a


83hp    58tq RE3 bike troy
81.5hp 58tq Bark2 bike gunz
72.5hp 60tq KDS2 bike Alkire
70hp    58tq Bo bike w/NOS 108hp 73tq Tonto

I can promise all but the KDS bike will continue to get tweaked on. I personally am hoping to get close to 90hp without changing bore, stroke, and compression. Once I get all I can out of it I really would like to throw a Barker3 or RE3 on her.

Put the 58tb on it and you should be much closer to what you are looking for.

I talked to troy last nite and I think I'm going to head up there for the cam test. While I'm there we plan on swapping his RE3 head with your cam over onto my bike, to see if there is a gain or not. Most likely I'll do a 58 vs 54tb on my build too. If you want to send me your stage 3 loaded up, we'll do a RE3 vs Barker3 head shoot out on my build, your cam in both heads.Your call. I'll send it back after the test.

[NaturalRaptor]

So right now we have a few big builds representing Racers Edge, Barker, KDS, and BO/NOS setup.


83hp    58tq RE3 bike troy
81.5hp 58tq Bark2 bike gunz
72.5hp 60tq KDS2 bike Alkire
70hp    58tq Bo bike w/NOS 108hp 73tq Tonto
69hp    58tq RE1 bike NaturalRaptor


I can promise the bark2, RE3, and NOS bike will continue to get tweaked on. I personally am hoping to get close to 90hp without changing bore, stroke, and compression. Once I get all I can out of it I really would like to throw a Barker3 or RE3 on her.

Dam that is a lot of numbers to keep up with, but quote change because I had 58 tq.

[funyun]

Natural is the only one on that list running pump gas right?

[Gunz]

Technically yes, but Roy's is built for pump gas too, minus the NOS.  Funyun send me a pm of what you are trying to do and accomplish  and I'll fix you up.

[Colorado700R]

mine will run on pump gas....



For maybe a minute

[Gunz]

Just so everybody knows my bike is free for anybody to ride at the rallys. Funyun you can take her for a spin at St Anthony's rally, just don't pull a Dorito on me.