Will a TPS, slightly off, rob HP/Tq?

[Krandall]

I tried reading the manual was freakin japanese to me. All I want to know how to do is this. that's all I forcee using this multi-meter for.

but. with the PCIII plugged in. do you guys know which wires it is between top mid and bottom? I suppose I can look it up in the manual to see which are which for the stock plug on the TPS.

[NaturalRaptor]

Krandall this will be hard to do with an analog meter. Does your analog meter go down to a 2 volt setting?      What is the lowest setting? Also you asked which wires are which. I did this last weekend so, sitting on the right side of the raptor looking at the connector, the middle is the positive and the top wire is the negative.  If you have any more questions just hollar.

[Krandall]

dang. No, from 1-10 its by 2.

Back to menards I go.

[1badazz_700r]

can you check it through the factory plug if its disconnected? If you can and it is an accurate reading mine is reading 4.27 on a digital meter. also what size are those torques bits to move the tps. im thinking a t-26

[Danny T]

did you end up fig this out randy?

[Krandall]

I found out my multimeter doens't go down to the level of reading I need

So I went ahead and adjusted through the PC App only. Runs like a beauty. 

[RaptorRandy]

Your TPS must be in spec then 

[Krandall]

that's what I'm guessing, but for peace of mind I'd like to test it still

[1badazz_700r]

finally got a test on mine.it read 70.0  so i guess its good

[RaptorRandy]

that's what I'm guessing, but for peace of mind I'd like to test it still

If it ain't broke.....don't fix it