+5mm stroker crank

[1badazz_700r]

well the crank is installed. I broke the rules for installation though. i tried freezing the crank and heating the case,no luck. So i used the flywheel and stator housing and pulled it in worked flawless. the only thing i ran into was the threads bottomed out on thecrank before the bearing was all the way in. So i took 2 9/16 short sockets and set them under the flywheel to give me a bit more thread and in it went. just thought i would share this even though its not the normal way people are doing it but it worked

[rutcutter]

Good to hear you got it in

[1badazz_700r]

Thanks rut. At the point i was at i really had no option.cause the bearing started in and then stopped and was stuck so i figured what the  am i gonna do now . that is what i came up with and i was about half sick the whole time thinking i was gonna break something,but it went right in

[dabigbratj]

glad you got it in

[Krandall]

What was the overall time process for this?

[NaturalRaptor]

Alright!  Time to  breaker her in.

[1badazz_700r]

it took me about 15 mins. to get it in once i figured out what i was gonna do. I still gotta wait for the piston to finish it up and heavy duty clutch springs. depending on what i end up with for clearence after i clay it i may have the head shaved a little for more compression