Raptor Not Starting...

Started by TeamYardsale, February 22, 2009, 12:34:50 PM

Previous topic - Next topic

TeamYardsale

Champion??

the one in my rappy is NGK cr8e.

I ordered a couple IX ones just for shits.
07 Yamaha Raptor 700 SE (Org/Blk)
GYTR Oval Race Pipe
GYTR Intake/Billet Adapter
GYTR Full Skids
Cobra Fi200r Fuel Programmer
ITP SS Wheels
Holeshot Tires

Peelz

Quote from: TeamYardsale on February 23, 2009, 01:10:52 PM
Champion??

the one in my rappy is NGK cr8e.

I ordered a couple IX ones just for shits.

Champion spark plugs. Cheap, they are everywhere. They make them in the next town over.
Krandall: "peelz. I'll be real with you. As much as I hate on you for soccer, I really don't mind it"


Onelunglow

So, here's a dumb question... Why can't you just clean the plug with gas and brush and put it back in? ???
06 - White Raptor
04 - Green KFX80
92 - White/Blue Banshee
88 - Lt500 Drag quad (ski-doo - 809 installed)

TeamYardsale

I could probably do that, but I like to do it right.

07 Yamaha Raptor 700 SE (Org/Blk)
GYTR Oval Race Pipe
GYTR Intake/Billet Adapter
GYTR Full Skids
Cobra Fi200r Fuel Programmer
ITP SS Wheels
Holeshot Tires

Kamakazi

Quote from: Onelunglow on February 23, 2009, 01:24:49 PM
So, here's a dumb question... Why can't you just clean the plug with gas and brush and put it back in? ???

use ether, cleans the sh^t right off, use to do that for the sled every time i went for a ride
98% of north americans that hit the ditch say "oh shit", the other 2% are from saskatchewan and say "hold my beer and watch this"



TeamYardsale

Just tried it really quick, started right up!

Im still going to get a couple new plugs.
07 Yamaha Raptor 700 SE (Org/Blk)
GYTR Oval Race Pipe
GYTR Intake/Billet Adapter
GYTR Full Skids
Cobra Fi200r Fuel Programmer
ITP SS Wheels
Holeshot Tires

Onelunglow

Quote from: TeamYardsale on February 23, 2009, 02:28:58 PM
Just tried it really quick, started right up!

Im still going to get a couple new plugs.

This was what I was getting at... If you did it and the raptor starts right up then you know what happened. (it's not a map issue)...

It's always go to have a few spares... :thumbs:
06 - White Raptor
04 - Green KFX80
92 - White/Blue Banshee
88 - Lt500 Drag quad (ski-doo - 809 installed)

Peelz

I get a new one, then clean the old one for a back up.
Krandall: "peelz. I'll be real with you. As much as I hate on you for soccer, I really don't mind it"


monster757

I spray it with ether then wipe it with a shop rag to get the heavy stuff off. Spray it again and light it then wipe it again and take fine sandpaper and clean it then reset the gap.

TeamYardsale

Ive never bothered with gaps.

I just took an electric wire wheel to it, spun wicked fast, polished it right up, re-installed started right up.
07 Yamaha Raptor 700 SE (Org/Blk)
GYTR Oval Race Pipe
GYTR Intake/Billet Adapter
GYTR Full Skids
Cobra Fi200r Fuel Programmer
ITP SS Wheels
Holeshot Tires

Krandall

Quote from: TeamYardsale on February 23, 2009, 06:19:36 PM
Ive never bothered with gaps.

I just took an electric wire wheel to it, spun wicked fast, polished it right up, re-installed started right up.



Good to hear it was something simple man  :thumbs: :thumbs: :thumbs:


Sponsored by:
Yamaha Raptor Forum

PCIII Maps Here:
http://www.krandall.com

Cowards die many times before their deaths The valiant never taste of death but once

Livingmylife93

My plug also fouls if i touch the throttle before it gets warmed up...