clutch problem

Started by raptorfireman, August 23, 2008, 08:40:29 AM

Previous topic - Next topic

raptorfireman

I'm replacing my clutch and i'm having trouble getting the big 27mm nut off. It's the nut that holds pressure plate 1 on the parts diagram. Is it standard or reverse thread? :help:
06 YFZ 450
TC Racing Motor (National Series)
TC Racing Exhaust (tuned to motor)
GYTR Air Filter
JB Racing Reinforced Frame
Lost Creek Cycles Steering Stabilizer
Pro Taper Contour Handle Bars
Rath Racing Nerfs,Bumper and Grab Bar
GYTR/Golden West Graphic Kit

exentix

i dont know but what clutch are you putting in it? i heard a few people had problems with the dirt digger clutch. rr34 on the forum said his only lasted 2 rides b4 it gave out. most people put a new stock one in from what i heard  :thumbs:

raptorfireman

I'm putting in the EBC clutch from RMATV.
06 YFZ 450
TC Racing Motor (National Series)
TC Racing Exhaust (tuned to motor)
GYTR Air Filter
JB Racing Reinforced Frame
Lost Creek Cycles Steering Stabilizer
Pro Taper Contour Handle Bars
Rath Racing Nerfs,Bumper and Grab Bar
GYTR/Golden West Graphic Kit

exentix

i remember hearing something about it but i dont recall if it was a positive something

raptorfireman

I finally got the f :mad:g nut off. I had to use an impact wrench. However, before trying this I managed to break off one of the spring studs off of the back pressure plate.  :'( Now i'm stuck waiting for the new part to come in.
06 YFZ 450
TC Racing Motor (National Series)
TC Racing Exhaust (tuned to motor)
GYTR Air Filter
JB Racing Reinforced Frame
Lost Creek Cycles Steering Stabilizer
Pro Taper Contour Handle Bars
Rath Racing Nerfs,Bumper and Grab Bar
GYTR/Golden West Graphic Kit