HID lights Question

[Onelunglow]

Well I just got around to installing my new HID lights from the second group buy! (I bought in the first group also) They don't work light I thought they would! With the bike not running only one light comes on! Then when the bikes is running the opposite will come on only! If I turn the switch on and off and on and off and back on again i can get both lights working! they seem to flicker a lot before they warm up. Is this normal? 

[Onelunglow]

does it mean i need a relay installed? what size? Are there different sizes?

[Onelunglow]

I need 1 relay for each light right!

[Spartan]

No you only need one relay kit to run both headlights

[Krandall]

You shouldn't need a relay to get both lights to work. (Unless your battery is that dead... )

If you hold the gas a bit just to a higher idle, can you get both lights to flicker? The only time they should do that is when there's not enough power to fully illuminate them. Like at a long idle, I get one light that will flicker a bit, but never when I'm on the gas.

[Onelunglow]

I didn't try gassing it. But my battery just came off the charger so it is fully charged. What comes with a relay kit? Thanks!

[MO RAPTOR 700]

Here is how I wired mine and they work fine.

http://www.moddedraptor.com/community/700-specific-how/4311-how-install-wire-up-hids.html

Scrolly down a few pictures and will see it.

[Onelunglow]

Thanks Mo... I'll be doing this setup tonight! 

[nikita]

Thanks Mo very much