Dynatek install help please

[double06]

I'm stuck on part 3b.  Some vague instructions, "connect to the wire thats above the starter motor and behind the throttle body."  Looks like I have found two that could possibly fit.  Anyway, if you look on the left side of the bike, as sitting on it, right where your duals would come up and over the case, there is a wire coming out.  If I trace this one all the way up, there is a big funky connector and two smaller ones.  The smaller ones have the right type of head that would fit the Dynatek.  So... which is it?  Both of the little ones appear to have the same color wires.  And, if I'm totally on the wrong part of the bike, its ok to tell me I'm all F d up!   :grin_nod:  I can handle it!

[Bert]

Your a better man than I as I own a DynaTek that's not installed 

[W69DY]

Dont worry i had the same problem. ok here we go. Now from what i remember, its the wire that is grouped with the wire that has the big whiteish clear plug. Theres only one big plug in the whole group, its about an inch wide and an inch long (insert joke here LMAORF). Anyways the wire that is grouped with that wire is the one you plug the dynatek in. Just disconnect and plug in the jumper from the dynatek. let me know if you have any question. WOODY

[double06]

That's exactly what I needed to know!  If I had Karma, I'd smack you with some!

[W69DY]

That's exactly what I needed to know!  If I had Karma, I'd smack you with some!

LOL NP!

[Krandall]

That's exactly what I needed to know!  If I had Karma, I'd smack you with some!

Done!

Thanks for the help Woody


If I'd get off my ass and get the one I have on mt shelf installed. I coulda helped 

[W69DY]

thanks WOODY