installation question

Started by 1badazz_700r, January 30, 2010, 12:36:42 PM

Previous topic - Next topic

1badazz_700r

I have a few questions, hoping someone can help. Im installing a whiteknuckle 54mm TB. Im wondering if the bolt hole im pointing to in the picture is where the tab on the intake bolts. Next question is the fuel rail will not mount flush against the throttlebody causing a slight gap at the top of the injector where it pushes into the fuel rail. Will this cause an issue? I bought a used RC 650 injector also, is there supposed to be a rubber seal on the bottom of the injector? cause it dont have one just the one on the top. Also the stock intake tube has a sensor that plugs in. the new intake tube has no spot for this?? what do you do with it? sorry for so many questions,and thanks for any help. pictures attached

Just a little 778
105.5 WK cylinder CP 11:1
hotrods +5 crank
racersedge +2 head,with webb4
54mmTB with custom intake
sparks X-6exhaust
PC5/w autotune
dynatek programmable
slingshot lockup
+3 stock swingarm
hiper dual beadlocks/w gncc holeshots
flexx bars,burgard+2stem/w antivibe
ASV's
odi's