Dynatek/PC3 issue- TPS

[Ranger]

Ok, I installed the dynatek according to the instructions (on an 08 Raptor 700r) and double checked all wiring connections...My Vapor is now reading 3,000 rpms at idle and on the PC itself I'm seeing 1500 and the TPS is bouncing all over the place, done the reset a few times...The only thing I can think of is I tapped the wire on the TB that was coming off the PC3 (all 3 wires black, tapped middle wire which is yellow on the harness)...It was programmed by DL and I tried both curve 2 and curve 4 (stock)...

[tonyrt44]

try to obtain the TPS reading with out running the engine.

[Ranger]

Done that, it mainly sticks at some random number...

[Ranger]

Fixed it, turned out the TPS was not recalibrating properly in the software and today it finally saved properly (IE I hit reset, opened up the throttle and closed, then SAVED it)...Gonna try a test ride a little later in the day.

[DL700]

sounds good