Port work

[DL700]

+1
no reason to skimp when u got the head off already... and then you will be ready for a bigger cam in the future

Yes, there is a reason to skimp. I'm broke now!
After ordering my I-shock LT kit I'm pretty well tapped out for now. I don't see me going any more the a HC3 anyways. Daniel you and Bo have told me I would not need springs with a HC3.

If DL and Bo told you that you don't need them well then.... you don't "NEED" them IMO. I trust those guys and many others will tell you the same. As Preddy said it's definitely a good safety precaution.....

I'm definitely think about doing it now that Preddy and DL brought it up. It does make sense to do it now while the head is off. I'll most likely have Bo do the spring also.

Can I run any cam I want with Bo's stock valve port job if I get springs?

 

yes u can run, the popular X2 x4 web 3 web 4 and my HDD5050 cam with that stock valve head,,,, check out my dyno tests on that setup....

[DL700]

waiting for the money to do the springs as well will save u the headache in the long run and not limit  your cam options just to the HC3

[MAN]

If I can run any of the bigger cams I want down the road. I think it is a no brainer! I'll get springs now.

Thanks for helping me save time and money later on.

[Krandall]

I thought you didn't have to clearance the rockers for the x-2? 

[Diggs59]

I thought you didn't have to clearance the rockers for the x-2? 

Read the suggested section in each of the builds at this link from TRF.

http://www.teamrocketfactory.com/Quads/Raptor-700R.html