PC3 and ignition module

Started by francky2000, October 06, 2008, 04:06:23 AM

Previous topic - Next topic

francky2000


I am getting an ignition module to run with my PC3, but cannot find any map to dowload in it...
anybody can help me with this?

thanks

Krandall

Map for the PC3 or for the Ignition Module?

Which did you end up going with? The one from Power Commander or the Dynatek?


Sponsored by:
Yamaha Raptor Forum

PCIII Maps Here:
http://www.krandall.com

Cowards die many times before their deaths The valiant never taste of death but once

francky2000

actually i got a map from fuel moto for the PC3 and had it readjusted on the dyno.
what i need now is an ignition timing map for the ignition module I went with the dynojet ingnition module...

Krandall

Gotcha. I'm not sure if they are available as "downloadable" maps.. I'm not 100% sure. From what I've heard though even with the Dynateks, is there isn't really a "ignition map" it's all custom set... But that could be totally different for the DynoJet version..


Sponsored by:
Yamaha Raptor Forum

PCIII Maps Here:
http://www.krandall.com

Cowards die many times before their deaths The valiant never taste of death but once

francky2000


I wrote to dynojet customer service i'll let you know if i got something from them.

Krandall



Sponsored by:
Yamaha Raptor Forum

PCIII Maps Here:
http://www.krandall.com

Cowards die many times before their deaths The valiant never taste of death but once

PDX Raptor

You need to get a custom curve set on a dyno. Until then you could run +2 across the board. I ran +2 and then bumped it to +4 over 5500 rpm.
Charlie

francky2000


Thanks I guess i will have no choice than going to the dyno and try to make it myself...
No answer yet from the tech support from Dynojet but they use to be pretty good I am sure it will come.