+4 Black SLC Ladder Swingarm-SOLD

[Sandeater]

Hey guys selling my +4.  

I bought it and was installed by Lance when he was in Salt Lake in May of 2008.  Someone took the quad up in the mountains (not a good idea without skid plates) and so they scratched the bottom of the carrier    I also noticed some water had gotten up in the weld by the pivot and saw a little bit of rust coming out.  I have contacted Lance with SLC Quad Customs about it but have not heard back from him yet.

I'm letting it go for $400 shipped.

Here is what you will need to install this swingarm (if going from stock):

-Extended brake line
-To cut the front chain slider down
-Shorter bolt to hold the chain slider on (I used several washers to make the bolt shorter also)
-New 1/2" diameter bolt where rear shock mounts to the swingarm ($2 at hardware store) or use several washers and keep the stock bolt.
-Might want new pivot bearings ($20/set and Lance @ SLC says to run 2 sets or check RMATV)
-Chain guide (possibly)

I wasn't able to get it cleaned up real well since its been cold here.  These pictures are with the chain guide (required) and that cost an extra $80 but will not be including it with the swingarm unless one comes with the other swingarm I'm looking at buying.

[Sandeater]

SOLD