RaptorSource.com

Raptor 700 Information => 700 Maintenance => Topic started by: Colorado700R on March 17, 2012, 09:53:49 AM

Title: THrottle Posititon Sensor Quick Reference
Post by: Colorado700R on March 17, 2012, 09:53:49 AM

Ignition on...

Adjust TPS Voltage:
• throttle position sensor angle

































a. Connect the throttle position sensor coupler
to the wire harness.
b. Connect the digital circuit tester to the throttle
position sensor.
   Positive digital circuit tester probe →
yellow 1
   Negative digital circuit tester probe →
black/blue 2

c. Measure the throttle position sensor voltage.
d. Adjust the throttle position sensor angle so
that the voltage is within the specified
range.
e. After adjusting the throttle position sensor
angle, tighten the throttle position sensor
screws.

(.63v-.73v)

Throttle position sensor resistance
0 ~ 5 ± 1 kΩ at 20 °C (68 °F)

(yellow-black/blue)
Positive digital circuit tester probe →
yellow 1
Negative digital circuit tester probe →
black/blue 2
Digital circuit tester
90890-03174
Model 88 Multimeter with tachometer
YU-A1927
Throttle position sensor voltage

Title: Re: THrottle Posititon Sensor Quick Reference
Post by: MORAPTOR700 on March 17, 2012, 11:04:16 AM

Nice Aaron another quick tip. On mine 08 don't know if they are all the same or not but if push up on the wiring connector end it will lower voltage reading (.73v - .68v) and opposite by raising the connector end (.60v-.68v).