Here is the Racers Edge CNC port for the 52mm billet TB.:grin_nod: These guys are always stealing my ideas right before I get them :confused:
(http://i233.photobucket.com/albums/ee157/kennybasham/52mmintakeport.jpg)
(http://i233.photobucket.com/albums/ee157/kennybasham/52mmintakeport-2.jpg)
(http://i233.photobucket.com/albums/ee157/kennybasham/52mmchamber.jpg)
I guess you need to work faster Kenny.
:lol:
Quote from: Socalrappy700 on June 26, 2008, 07:03:23 AM
I guess you need to work faster Kenny.
:lol:
Answering PM's would be a good start :rofl:
Quote from: Kenny on June 26, 2008, 07:17:45 AM
Quote from: Socalrappy700 on June 26, 2008, 07:03:23 AM
I guess you need to work faster Kenny.
:lol:
Answering PM's would be a good start :rofl:
I'm trying to figure out how to put the bouncing karaoke ball over posts to keep your attention :lol:
Quote from: Kenny on June 26, 2008, 06:55:46 AM
Here is the Racers Edge CNC port for the 52mm billet TB.:grin_nod: These guys are always stealing my ideas right before I get them :confused:
(http://i233.photobucket.com/albums/ee157/kennybasham/52mmintakeport.jpg)
(http://i233.photobucket.com/albums/ee157/kennybasham/52mmintakeport-2.jpg)
(http://i233.photobucket.com/albums/ee157/kennybasham/52mmchamber.jpg)
Great pics!...I like seeing a port job without the polishing!! the seats could have a little blending though! :thumbs: :thumbs:
Good catch....The ports have been cut to shape, but the valve seats have not been finished. The exhaust will be a full radius, while the intake the intake will use distinct angle changes. All of them will be cut on Newen CNC equipment :thumbs: