Hey guys selling my +4.
I bought it and was installed by Lance when he was in Salt Lake in May of 2008. Someone took the quad up in the mountains (not a good idea without skid plates) and so they scratched the bottom of the carrier :mad: I also noticed some water had gotten up in the weld by the pivot and saw a little bit of rust coming out. I have contacted Lance with SLC Quad Customs about it but have not heard back from him yet.
I'm letting it go for $400 shipped.
Here is what you will need to install this swingarm (if going from stock):
-Extended brake line
-To cut the front chain slider down
-Shorter bolt to hold the chain slider on (I used several washers to make the bolt shorter also)
-New 1/2" diameter bolt where rear shock mounts to the swingarm ($2 at hardware store) or use several washers and keep the stock bolt.
-Might want new pivot bearings ($20/set and Lance @ SLC says to run 2 sets or check RMATV)
-Chain guide (possibly)
I wasn't able to get it cleaned up real well since its been cold here. These pictures are with the chain guide (required) and that cost an extra $80 but will not be including it with the swingarm unless one comes with the other swingarm I'm looking at buying.
(http://i70.photobucket.com/albums/i94/powerstrokeme/For%20Sale/100_3578.jpg)
(http://i70.photobucket.com/albums/i94/powerstrokeme/For%20Sale/100_3580.jpg)
(http://i70.photobucket.com/albums/i94/powerstrokeme/For%20Sale/100_3579.jpg)
(http://i70.photobucket.com/albums/i94/powerstrokeme/For%20Sale/100_3581.jpg)
(http://i70.photobucket.com/albums/i94/powerstrokeme/For%20Sale/100_3582.jpg)
SOLD