RaptorSource.com

Raptor 700 Information => 700 Motor Mods => Topic started by: PnoT on July 08, 2009, 03:22:57 PM

Title: CAM identification help needed - pic included
Post by: PnoT on July 08, 2009, 03:22:57 PM
I wanted to know if anyone knew what the cam below is so i can set the proper valve clearances.

(http://img216.imageshack.us/img216/2981/img0967w.jpg)
Title: Re: CAM identification help needed - pic included
Post by: tonyrt44 on July 12, 2009, 03:47:42 AM
You ought take that cam out, there could be some more engravings other places.

by looking @ this photo, it is hard to tell anything except it is regrind (not billet)
Title: Re: CAM identification help needed - pic included
Post by: Tim Barker on July 16, 2009, 08:59:00 AM
did you figure out what it was yet
Title: Re: CAM identification help needed - pic included
Post by: PnoT on July 23, 2009, 04:25:00 PM
With some help from another forum, cough, they were leading us to believe it was an older web and after doing some research my brother came close to those markings but nothing solid yet.

He's going to have his engine completely tore down here soon and we'll know for sure.  I'll make sure to update this thread if there are clearer markings when it's out and about.
Title: Re: CAM identification help needed - pic included
Post by: Diggs59 on July 24, 2009, 12:03:41 AM
Quote from: PnoT on July 23, 2009, 04:25:00 PM
With some help from another forum, cough, they were leading us to believe it was an older web and after doing some research my brother came close to those markings but nothing solid yet.

He's going to have his engine completely tore down here soon and we'll know for sure.  I'll make sure to update this thread if there are clearer markings when it's out and about.


What did he think he was purchasing when he purchased it?
Title: Re: CAM identification help needed - pic included
Post by: PnoT on July 26, 2009, 07:45:40 PM
Quote from: Diggs59 on July 24, 2009, 12:03:41 AM
Quote from: PnoT on July 23, 2009, 04:25:00 PM
With some help from another forum, cough, they were leading us to believe it was an older web and after doing some research my brother came close to those markings but nothing solid yet.

He's going to have his engine completely tore down here soon and we'll know for sure.  I'll make sure to update this thread if there are clearer markings when it's out and about.


What did he think he was purchasing when he purchased it?

My brother bought the bike used and only had to go off of what the seller told him was in it and that didn't include what type of cam was installed.
Title: Re: CAM identification help needed - pic included
Post by: PnoT on August 01, 2009, 10:50:46 AM
This cam turned out to be a Web 3!