RaptorSource.com

Raptor 700 Information => 700 Motor Mods => Topic started by: PnoT on July 05, 2009, 12:40:55 PM

Title: PC3 Map Needed: ProDesign K&N, Barkers, and HC2
Post by: PnoT on July 05, 2009, 12:40:55 PM
Does anyone have a map for this type of setup?

Title: Re: PC3 Map Needed: ProDesign K&N, Barkers, and HC2
Post by: Ranger on July 05, 2009, 12:43:20 PM
http://www.pciii.raptorsource.com/
Title: Re: PC3 Map Needed: ProDesign K&N, Barkers, and HC2
Post by: PnoT on July 05, 2009, 01:04:52 PM
Nothing close to what i have thou   :(
Title: Re: PC3 Map Needed: ProDesign K&N, Barkers, and HC2
Post by: Ranger on July 05, 2009, 01:08:49 PM
Just get something for Barkers and Pro design and then adjust your map a bit...Everyone's bike will run differently with the same map and usually needs a little fine tuning
Title: Re: PC3 Map Needed: ProDesign K&N, Barkers, and HC2
Post by: Gunz on July 05, 2009, 01:17:20 PM
Ive got a map for you, pm me your email. Barker/prodesign k&n/hc2
Title: Re: PC3 Map Needed: ProDesign K&N, Barkers, and HC2
Post by: Ranger on July 05, 2009, 01:29:55 PM
Damn gunny, seems like a lot of people are after your map today haha...You should upload it to that site