RaptorSource.com

Raptor 700 Information => 700 General Discussion => Topic started by: r00st on February 25, 2009, 01:41:09 AM

Title: What did you pay to dyno your quad? How much to make a PC3 map?
Post by: r00st on February 25, 2009, 01:41:09 AM
I will have my build done in the next couple of weeks. I have a few sources to get a map that will be close but of course I am looking to make it as good as I can get. Who knows, it might be so close I will be confident in running it but I would at minimum like to throw it on the dyno to A) get the numbers and B) check the AFR throughout the rev range.

So...what have you guys paid for dyno pulls? (was it based on # of pulls, or per half hour or hour?)

How about to make a full custom map (starting with nothing? Or did you have a map that was kind of close already?)

I am going with a friend on saturday to pick up a new bike and the dealership up there has a dyno. I am going to ask how profecient they are with tuning PC3 equipped bikes and what their rates are.

Thanks :D
Title: Re: What did you pay to dyno your quad? How much to make a PC3 map?
Post by: 1badazz_700r on February 25, 2009, 02:27:57 AM
I payed $150.00 for about 6 hours :grin_nod: it took forever cause the guy was dickin around,then my quad overheated his dynoand had to stop to let it cool. make a long story short, i left there with a 38hp and 34 lbft of torque raptor with a melted set of gncc holeshot back tires. with the mods in my signature.however the tune is great just had low numbers  ???
Title: Re: What did you pay to dyno your quad? How much to make a PC3 map?
Post by: preddy08 on February 25, 2009, 08:50:26 AM
I typically pay 100-150 for a dyno tune. Your best bet is to load up a tune that is as close as possible that way your dyno guy does'nt have to waste time getting it to that point.
Title: Re: What did you pay to dyno your quad? How much to make a PC3 map?
Post by: dabigbratj on February 25, 2009, 09:43:41 AM
im going to tony tice and he is 95 hr and told me should take hour and a half
Title: Re: What did you pay to dyno your quad? How much to make a PC3 map?
Post by: dabigbratj on February 25, 2009, 09:52:36 AM
just talked to him again and one thing he said is he cant think of one time it has taken over 2 hours plus alot of people recomend him