??? ?
You can run it you just can't see if it gives you any codes or anything else.
OK :clap: Cause its suppose to go on the dyno in the morning and whats left of the front plastic and dash is in my trailer :lol:
yeah it wont let you go wide open if the reverse or neutral light is disconnected or has a bad connection.
Quote from: BRAD on September 09, 2008, 06:22:22 PM
yeah it wont let you go wide open if the reverse or neutral light is disconnected or has a bad connection.
You sure? ???
Quote from: Sand84 on September 09, 2008, 06:35:47 PM
Quote from: BRAD on September 09, 2008, 06:22:22 PM
yeah it wont let you go wide open if the reverse or neutral light is disconnected or has a bad connection.
You sure? ???
yeah my little cousin had this problem sunday night. his plug worked loose and it tripped his reverse light and he coulnt get over half throtle or he was bouncin the revlimiter
I raced all weekend without any of my plastic on the bike. Bike ran great!
hmm maybe theres somethin else wrong with my little cousins rappy then. but when he plugs that sensor back in good an tight it runs fine until it works alittle loose again
Quote from: jwraptor on September 09, 2008, 07:40:08 PM
I raced all weekend without any of my plastic on the bike. Bike ran great!
I rode it around the yard with it disconnected and it seemed fine.... :thumbs: Thanks
dirt in the connectors maybe, but that's it.
Aaron