Raptor 660 Information > 660 Maintenance

How To: Remove PB Sensor

<< < (2/2)

ThisGuyAlex:
nice write up.... :thumbs:

ThisGuyAlex:
maybe i'll do this 2day cuz i'm dead at the shop ???

zacharkins:
i like the write up you did but what is the purpose of taking it off?   

Peelz:

--- Quote from: zacharkins on December 22, 2008, 08:43:15 AM ---i like the write up you did but what is the purpose of taking it off?   



--- End quote ---


YAY! a 660 question! :lol:

Removing the pB sensor is just a way to eliminate future trouble. IF the contacts go bad and closes the circuit on the clutch lever, it idiots the ignition at 3000 rpm I think. Happened to me at the badlands, I rolled my quad, and cracked the sensor. COuldn't rev the engine anymore.
Oh and weight savings when you remove the parking brake itself, and the lever. :thumbs:

All you have to do is remove the plug cut the wires and seal them off, then replace the plug. Then pull the cable, lever and mechanism. WHich I have not done completely. Just the plug part should only take 10 minutes.

Navigation

[0] Message Index

[*] Previous page