Power Commander Maps Here!

[gofast68]

I wish I could. I have officially broke the bank, so pending repairs, the stroker will have to wait.

[Colorado700R]

if you were to add a +5 stroker to that, it'd be exactly the same as mine

[gofast68]

Well, send me a copy of yours and I'll tone it down a little. 

[Colorado700R]

Well, send me a copy of yours and I'll tone it down a little. 

will do, I'll have to send it from home

[bustedplastic]

So I'm back to completely stock motor, stock airbox, lid on, foam filter.  Only thing left is Monster Pipes.  I ripped the power commander out, ran it for a couple hours, running too lean.  Put a "GYTR Full System Stock Box Lid On" map on the pciii, threw it in, and it's too rich.  Anyone have a good suggestion for a map for this setup? 

Im not pulling my lid (i go through a lot of water and mud) or putting a K&N filter (ride in very dusty conditions), and I'm not putting any more money into mods.  I'm wondering if i should just scrap the exhaust and go back to stock...

[daleford2004]

im looking for a pc3 map for my raptor. im running a standard bore 11:1 compression with a ported and polished head from alba, iridium spark plug, DG full exhaust, aftermarket cdi to raise timing and rev, no air box with a oversize k&n filter also run 110 oct race gas. email me at dillin1234@hotmail.com thanks

[darkliquid]

Hi everyone, i am from venezuela and i have a 2009 Raptor 700R with some mods please can you help me to find one tune for my mods.

PCIII
Yoshimura RS2 Full Exhaust
K&N Filter
HotCams Stage 2

Thanks for your Help.
 

[Krandall]

Hey Dark, Welcome aboard!!!!

I think the closest map we'll have for you is this:

GYTR Full - GYTR Intake- 11:1 piston, HC stg2 (dl700)


the piston won't matter to much as it doens't change your Air/Fuel ratio. Not sure the differences between the 2 pipes. But it'll get you close to start at least.



Make sure to post up some pics of your ride/introduce yourself here: http://www.raptorsource.com/forum/index.php?board=76.0

[8ballexpress]

hi guys. need a map for a stoke bore 12:5:1 piston, 54mm tb, dasa duals, hc stage 3, and wk fci intake thanks.. AL

[Colorado700R]

hi guys. need a map for a stoke bore 12:5:1 piston, 54mm tb, dasa duals, hc stage 3, and wk fci intake thanks.. AL

that Cam and TB combo is gonna make finding one tough.  I'll keep my eyes out for one though

[8ballexpress]

ok thanks i just need something to tide me over til i get it to the dyno..

[8ballexpress]

anything close would help guys..

[Krandall]

Yeah, we don't have anything w/ a 54mmTB.. I'll put the word out w/ some others and see if I can find something.

[MoRaptor06]

Hello All  I am looking for a map for my  06 Raptor 700 LTE'S,105.5mm JE piston, Stage II hotcam, PCIII, ProFlow intake and Proflow/Foam, ported and polished head.
My Email address is dcc00@hotmail.com please put 700 map or something like that in the subject line.

Thanks for any help

[Krandall]

what kind of port do you have?