Thank you guys very much for the nice compliments and excellent adice. I really appreciate it and am in no way offended by the suggestions. All valid points.
I shall respond to all three replies prior to this post.
@ Krandall. I only have a Stage 2 Hotcam in. But I am in the process of ordering parts for some extra mods. Going to have cylinder head portwork done by Freez (some might know him from quad forums). Going for +2 Valves, +3 Throttle Body, Hotcam Stage 3, and some of Freez's secret timing curves
@ Moraptor700. I used to live in Cape Town, basically grew up there and went to school. Now I live 900 kilometers north of Cape Town, in a small town in the Kalahari Desert. Escaped escalating crime
@ Preddy08. Thanks for the heads up on the hubs. I have read about that issue. But like you said, great price to widen the rear. Gotto admit, I have given it some punishment, but not enough to tell! So when it does bend the day, out will come the stock axle, in will go RPM Dominator II.
@ Preddy08. The stock stem and rox risers are a bit of an issue for me as well. Everyday I look on ebay at an aftermarket replacement. I really like the ASR (American Star Racing) steering stems. They make good products, got a set of ASR a-arms on my wifes Raptor 350. But I am not sure how the lengths work. I want my handlebar setup to be one inch higher than what it is now. I want to toss the rox risers. They are 2". So what setup do I get to give me one inch higher than what I have now? With steering stems, do they come same length as OEM? And to increase height you have to request 3" antivibe risers? So what I want is an aftermarket stem with antivbe clamp, and the total height must be 1 inch higher than my current set up with stock stem, 2" rox risers and flexx bars. I am not sure what length aftermarket steering stem and antivibe risers to order to give me a setup 1" higher than my current setup. Advice shall be appreciated greatly.