im pretty sure the oem raptor POD is following the R1 but need some conformation from another 09 .............
Changing fuel settings. This only effects the first 25% of throttle. If you do not know how to read a plug do not mess with this setting. Check your plug after making a change.
1. Hold "Select" & "Reset" and while holding them down turn the key on. The "d IAG" screen will pop up in 5-10 seconds.
2. Press Select to get it to the "Co" screen.
3. Hold "Select" & "Reset" again to get the "C1" screen to pop up.
4. Press "Select" & "Reset" again.
5. Press "Select" to raise the number and press "Reset" to lower the number.
6. Turn the key off to set the setting and start riding.
Tempature of engine coolant.
1. Hold "Select" & "Reset" and while holding them down turn the key on. The "d IAG" screen will pop up in 5-10 seconds.
2. Hold "Select" & "Reset" again to get the "Do1" screen to pop up.
3. Press Select to get it to the "Do6" screen.
4. The number listed is the tempature in celsious. 96c is 205f
5. starting bike and riding will keep that screen up.
6. Turn the key off to return to standard screen.
Engine rpm.
I can not find or remember where this one is but I know I you can show it (i found it in the first screen when i started the bike )
Here are some more. Diagnostic code number on display followed by checking method.
D01
Throttle angle
• Fully closed position 15 ~ 20 Check with throttle fully closed.
• Fully opened position 95 ~ 100 Check with throttle fully open.
D03
Pressure difference (atmospheric pressure and intake air pressure).
Displays the intake air pressure. Set the engine stop switch to "RUN", then operate the throttle while pushing the start switch. (If the display value changes, the performance is OK.)
D05
Intake air temperature.
Displays the intake air temperature. Compare the actually measured intake air temperature with the meter.
D07
Vehicle speed pulse 0 ~ 999
Check that the number increases when the rear wheel is rotated. The number is cumulative and does not reset each time the wheel is stopped.
D08
Lean angle sensor Remove the lean angle sensor and...
• Upright 0.4 ~ 1.4 incline it more than 65 degrees.
• Overturned 3.7 ~ 4.4
D09
Fuel system voltage (battery voltage): Approximately 12.0
Set the engine stop switch to "RUN", and then compare with the actually measured battery voltage. (If the battery voltage is lower, perform recharging).
D21
Neutral switch Shift the transmission.
• Neutral ON
• In gear OFF
D60
EEPROM fault code display.
• No history 00
• History exists 01
D61
Malfunction history code display.
• No history 00
• History exists Fault codes 12-50
• (If more than one code number is detected, the display alternates every two seconds to show all the detected code numbers. When all code numbers are shown, the display repeats the same process.)
D62
Malfunction history code erasure.
• No history 0 —
• History exists Up to 16 fault codes To erase the history, set the engine stop switch to "OFF" and then to
"RUN".
D70 Control number 00 ~ 255