well the crank is installed. I broke the rules for installation though. i tried freezing the crank and heating the case,no luck. So i used the flywheel and stator housing and pulled it in
![thumbs up :thumbs:](https://raptorsource.com/forum/Smileys/custom/thumbsup.gif)
worked flawless. the only thing i ran into was the threads bottomed out on thecrank before the bearing was all the way in. So i took 2 9/16 short sockets and set them under the flywheel to give me a bit more thread and in it went. just thought i would share this even though its not the normal way people are doing it but it worked
![:lol: :lol:](https://raptorsource.com/forum/Smileys/custom/lol.gif)