RaptorSource.com

Raptor 660 Information => 660 Maintenance => Topic started by: Flynbyu on May 08, 2008, 08:51:18 PM

Title: Jetting that works
Post by: Flynbyu on May 08, 2008, 08:51:18 PM

Please post your jet settings, and what works for you!

Location:        Fort Smith, AR USA
Elevation:       466 feet above seal level (ASL)
Main jets:       Mikuni 155 left carb, 160 right carb
Pilot jets:        Mikuni 25
Needles:         Stock
Mixture screw: 2.5 turns from full seated

Modifications: Yoshimura Full system, Airbox lid in place, snorkel modified.

~Brian

Title: Re: Jetting that works
Post by: DECEPTiON21 on May 08, 2008, 09:26:51 PM

Location:Phoenix, AZ
Elevation:1200 ft
Jet Type: Mikuni mains and pilots, CT needles
Intake Mods:NO box, Pro-flow with K&N air filter
Exhaust Mods: CT Full System, 16 discs (as it comes from CT)
Porting/Motor Mods: None
Other: Crankcase Breather


Jetting
Pilots: 25
Fuel Screws: 2.75 for both
Needles: 3rd Clip
Mains: 170/175 L/R

Title: Re: Jetting that works
Post by: Limited660 on May 08, 2008, 09:43:25 PM

This is mine :thumbs:
(http://img509.imageshack.us/img509/7490/raptor660jettingpc9.jpg)